Yamaha YZF-R7 Forum banner

What to do with the front wheel sensor for ABS deleted Race/Track Bikes

762 Views 2 Replies 2 Participants Last post by  research monkey
3
Posted up on FB but not getting many responses... What did you guys do with your extremely long front wheel sensors after switching to a non ABS brake line setup? In my head I want to pull the mount off the left caliper, rerun the line against the new brake line on the right side, then just wrap it up and zip tie it to the area that is open now that the ABS pump is gone.

Attachments

See less See more
  • Like
Reactions: 1
1 - 3 of 3 Posts
I ran it straight up from the wheel, zip tied to the brake line, then coiled up the excess up on the right side (the route it naturally goes), zip tying and securing it place. Just make sure there is enough slack for the suspension movement, following the brake line will do that.
  • Like
Reactions: 1
I ran it straight up from the wheel, zip tied to the brake line, then coiled up the excess up on the right side (the route it naturally goes), zip tying and securing it place. Just make sure there is enough slack for the suspension movement, following the brake line will do that.
Pretty much what I ended up doing. Unplugged/unmounted at the plug. Removed the left mounting bracket. Ran back up from the right along the brake line and through the mount on top of the lower triple, then up and coiled / ziptied in the area that the ABS unit used to be.
  • Like
Reactions: 1
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top