[EL_BOMBERO]

The sparks exhaust system doesn't work with sharkskinz bellpan. The loop in the exhaust hits the back wall of pan. I would have to trim to much off to make it work. And that mean I will not pass tech inspection. Options r replace exhaust or reform pan, or put a buffer wall before exhaust loop, but not sure if that will pass tech.

 

[Vansmack]

Adjust the pan? Extend or bring it in some? There is just not a lot of room available to deal with a drooping exhaust on these bikes. High and tight is not easy, and certainly not what most exhaust manufacturers are thinking in their designs. Bummer.

 

[EL_BOMBERO]

 

[Vansmack]

That's a big loop. I haven't seen that before. Hopefully that is good enough. If not build a new wall inward?

 

[EL_BOMBERO]

That's what I was thinking. A wall right before the loop would b the easiest route to take.

 

[EL_BOMBERO]

Problem solved.