Yamaha YZF-R7 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hey All,

Was looking through the service manual and it really made no sense to me. Here is what the service manual says:
Product Font Fashion accessory Machine Titanium


However it says to insert a crosshead screwdriver into the cutout but I cant for the light of me figure out what cross head screw I'm supposed to turn. Anyone done an adjustment on the R7?
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #2 ·
Well maybe it was a bit premature to ask but just incase anyone else is confused. I removed the panel (probably not required) under the headlight and this video helped clear it up for me. While this is not for the R7 this is similar. Where you see his nob's rails going into the bolt is where your screwdriver would go. There is a small opening there to put a crosshead screwdriver. Insert and turn. Clockwise screw driver turns raises the lights. In the diagram above, where the head of the left arrow is, is where the screwdriver's spot is. Its not really a screw more like a gear your are turning by hand. Note: There is also a left to right adjustment on the left side
Automotive tire Tire Wheel Alloy wheel Rim
 

Attachments

1 - 2 of 2 Posts
Top